LAWR

21 Annual Guide 2014 | Source TeSTing ASSociATion Compound/Method Standard number Description MID Methane – FID BS EN ISO 25140:2010 Automatic method for the determination of the methane concentration using FID Moisture/water vapour BS EN 14790:2005 Determination of the water vapour in ducts Nitrogen Oxides (NOx) BS EN 14792:2005 Determination of mass concentration of nitrogen oxides (NOx). Reference method: Chemiluminescence Nitrous Oxide (Dinitrogen BS EN ISO21258:2010 Determination of the mass concentration of dinitrogen monoxide (N 2 O). Monoxide) (N 2 O) Reference method. Non-dispersive infrared method Odour BS EN 13725:2003 Determination of odour concentration by dynamic olfactometry Oxygen BS EN 14789:2005 Determination of volume concentration of oxygen (O2). Reference method. Paramagnetism PAH analysis BS ISO 11338-2:2003 Determination of gas and particle-phase polycyclic aromatic hydrocarbons. Sample preparation, clean-up and determination PAH sampling BS ISO 11338-1:2003 Determination of gas and particle-phase polycyclic aromatic hydrocarbons. Sampling Particulate BS ISO 12141:2002 Determination of mass concentration of particulate matter (dust) at low concentrations. Manual gravimetric method Particulate/Dust BS EN 13284-1:2002 Determination of low range mass concentration of dust. MID 13284 Manual gravimetric method Particulate calibration BS ISO 10155:1995 Automated monitoring of mass concentrations of particles. Performance characteristics, test methods and specifications Particulate calibration BS EN 13284-2:2004 Determination of low range mass concentration of dust. Automated measuring systems Particulate high range BS ISO 9096:2003 Manual determination of mass concentration of particulate matter Particulate BS EN ISO23210:2009 Stationary source emissions — Determination of PM10/PM2.5 mass PM 2.5 and PM 10 concentration in flue gas —Measurement at low concentrations by use of impactors. Particulate BS ISO 13271:2012 Determination of PM10/PM2.5 mass concentration in flue gas – PM 2.5 and PM 10 for Measurement at higher concentrations by use of virtual impactors high concentrations. Particulate BS ISO 25597:2013 Test method for determination of PM2.5 and PM10 mass in stack gases using PM 2.5 and PM 10 – Test cyclone samplers and sample dilution method using cyclones Planning BS EN 15259:2007 Air Quality – Measurement of stationary source emissions – Requirements for MID 15259 measurement sections and sites and for the measurement objective, plan and report Smoke BS 2742:2009 Notes on the use of the Ringelmann and miniature smoke charts Sulphur Dioxide (SO 2 ) BS EN 14791:2005 Determination of mass concentration of sulphur dioxide. Reference method TVOC BS EN 12619:2013 Determination of the mass concentration of total gaseous organic carbon at low concentrations in flue gases. Continuous flame ionisation detector method TVOC by NDIR for BS ISO 13199:2012 Determination of total volatile organic compounds (TVOC) in waste gases from non-combustion sources non-combustion processes – Non-dispersive infrared method equipped with catalytic converter VOC speciation TS 13649:2014 Determination of the mass concentration of individual gaseous organic compounds. Activated carbon and solvent desorption method Further guidance and advice The Source Testing Association provides guidance to its membership and their clients. This includes methodology advice, guidance on equipment selection and training. Visit the STA website for details www.s-t-a.org or for any technical question contact airanswers@s-t-a.org or telephone +44(0) 1462 457535. Standards are generally revised after five years and this process will affect many of the published standards. STA Article 6 WP.indd 21 05/02/2014 19:50

• Cover